How to mount a front license plate on a 2002 thunderbird

HOW TO MOUNT A FRONT LICENSE PLATE ON A 2002 THUNDERBIRD INSTALL

The 49 mm high typeface had already received the green light from the police before it was introduced and only had to be approved by various authorities and agencies. So that all information can be accommodated, the so-called вЂњminiature center fontвЂќ, which many motorcyclists already know from light motorcycles or tractors, is used.

HOW TO MOUNT A FRONT LICENSE PLATE ON A 2002 THUNDERBIRD INSTALL

Install the license plate holder using the two bolts (and washers) provided. Make holes on the plastic finisher at the location mark (small dimple) using a 0.37 in (9.5 mm) drill. The two holes can be covered with two small plastic cosmetic fasteners.

Its pretty easy really, just get a drill bit thats slightly larger in diameter than the hole in the middle of the rivet, drill the sucker until it pops off, and voila. If it should be even smaller, the license plate for show purposes can be further shortened and stuck in a 16Г—20 cm Inside Plate, which is in comparison to the previously 280mm wide license plate an enormous leap. 2002-2004 Thunderbird Front Fender Emblem/Louver Plate This is the вЂLouver/EmblemвЂ™ that was featured on the front fender of all 2002-2004 Thunderbirds (the 2005 featured a special вЂ™50th AnniversaryвЂ™ emblem). Use the following steps to mount the front license plate: 1. For a 2001/2002, you have to drill the rivets out since theyre rivets and not bolts or screws. However, the legislature has decided on the binding width of 18Г—20 cm, for which we have adjusted our inside plates and stainless steel plates. Then shop at 1A Auto for a Ford Thunderbird License Plate Mounting Bracket, at a great price. The dealer drilled two hole in the front end and a couple bolts, washers and nuts and the job was done. The 2015 Excursion I bought had no front plate mount. With a happy short letter and number combination would be theoretically characteristics of a license 110 mm wide and 200 mm height. remove the license plate with the frame.-under the license plate, Unscrew the two screws.-release the latch and gently pulls the bumper forward with the assistant.-snap together the connectors of electrical equipment. California also requires a front plate on motorhomes.

How to mount a front license plate on a 2002 thunderbird